|
- November 2002 -
November 12th, 2002
OptoWise
is launching 3 Innovative Fiber–optic Products at ITU Telecom Asia2002
OptoWise
Technologies Ltd, (OptoWise) located in Hong Kong, is going to launch
three innovative fiber-optic products, which aim to improve the quality
and the ease of maintenance of the existing fiber networks. Those products
that will be displayed at ITU Telecom Asia2002 Exhibition in Hong Kong
Exhibition and Convention Center by Go4Fiber Ltd (Booth No.: 1207.029,
Hall 1) are:
Portable
Light Path Performance Monitor (Portable LPPM)
Combining
a compact optical engine equivalent to a small optical spectrum analyzer
and a handheld PDA, OptoWise’s Portable Light Path Performance Monitor
facilitates technologists to manage and maintain CWDM/DWDM optical
networks in the field without the need to use bulky optical spectrum
analyzer to do the measurements. This Portable LPPM provides accurate
measurement on peak wavelength, optical signal power, optical
signal-to-noise ratio (OSNR) of each DWDM channel located in ITU grids.
User-friendly PDA or PC graphical user interface allows technologists to
compare channels, set alarm thresholds, identify new or missing channels
and extract optical parameters. All measured data can be converted into
Excel readable format in Pocket PC or uploaded to desktop PC.
Light
Path Protection Switch (LPPS)
:
OptoWise’s Light Path Protection Switch offers a dedicated 1+1 optical
restoration scheme to realize a survivable optical network. In this
method, a dedicated link-disjoint backup route is set up in advance at the
time of connection setup. Upon a link failure on the primary path such
that its light power is lower than the threshold value, the end-nodes of
the connection start utilizing the secondary path to restore the light
patch connection automatically within 25ms. The status for both primary
and secondary path is always monitored by a microprocessor. Maintenance
staff can access and monitor link power via internet, dial-up modem,
RS232, or SNMP. Alarm notification is also available via local alarm,
remote PC, mobile phone SMS, fax and emails to allow immediate attention
to the problems.
MT-RJ
Visual Fault Locator (MT-RJ VFL)
:
MT-RJ Visual Fault Locator (VFL) allows simultaneous testing of duplex
fibers for MT-RJ application. OptoWise MT-RJ VFL surpasses industry
requirement as it works with both singlemode and multimode MT-RJ
applications. Breaks, bad splices, tight crimps, faulty splice and bad
connection can be identified by means of visible red laser emitting from
VFL. By changing an optical adaptor, engineers can use the same VFL to
test their 1.25mm ferrule (such as LC connector) and traditional 2.5mm
ferrule (such as FC/SC/ST connector) singlemode and multimode
applications.
About
OptoWise Technologies Ltd.
OptoWise
Technologies Ltd. is located in Hong Kong. OptoWise designs and
manufactures fiber-optic components and sub-systems for the optical
networking industry. OptoWise has developed a new generation of
user-friendly Optical Path Protection and Optical Add/Drop products that
significantly improve the quality of current fiber-optic networks.
OptoWise also manufactures high quality fiber-optic reference/measurement
jumpers, MTRJ/ribbon and dense interconnect jumpers, optical cable
management device and miniature loop-back attenuators. OptoWise -the
Wisdom in the Opto Industry.
About Go4Fiber Ltd.
Go4Fiber is comprised
of a group of experienced fiber-optics professionals who are experts in
areas of outside plant installation, connector polishing/assembly,
transmission systems, datacom, CATV and testing. Go4Fiber offers
Connector, Adaptor, Fiber Cable, Patchcord, Testing Equipment, Tools,
Consumables, Splicing Products, Cable Management Tools, Attenuator,
Splitter, Active and Passive Component as well as Active Networking
Equipment.
For
more information visit: www.go4fiber.com
or www.optowise.com
|
|
